HELP Olipro Unlocker could not unlock my SIMLOCK BUT CID is unlock, Radio is flash - Advantage X7500, MDA Ameo Upgrading

I used Olipro unlocker to Unlock my phone. My phone was T mobile UK Ameo.
I followed all the three steps and the CID is Unlock, Radio is flashed WITH 1.57 VERSION.
My Rom is flashed with AP 3 rom.
When I changed myT mobile sim card to Orenge sim CARD, It indicates the SIM is locked. I am not sure what I should do to unlock the SIM.
I am travelling overseas and want to use the phone outside UK.
Please need advice.

Thanks for everyone who read this thread but could not provide solution.
I used IME-CHECK software to unlock the phone. So the sim is now unlocked.

Related

Will Upgrading the ROM re-lock a phone I had unlocked?

When you unlock the phone, what gets unlocked ? The phone or your sim card ? Here is my real problem:
I originally had the XDA 1 from T-Mobile, bought an XDAII on Ebay, was told it was unlocked, but it was not. Ran the xda2unlock program from your website, it unlocked the phone so I could use the phone itself with my old SIM card from T-Mobile. Now I see there is a new ROM from O2, the question is, if I run that, will the unit be locked once again, and since the Radio verison on the new ROM is 1.17, and the xda2unlock only works on 1.10 radio stack (as said on the download site here) will I then be stuck with a phone with a new ROM that is once again locked - that I won't be able to unlock ? I don't want to try this unless I am fairly certain it is a safe thing to do... :? :? :?
it wont re-lock the phone if you upgrade
When you unlock the phone, what gets unlocked?
Where is the information stored that determines if a phone is unlocked or locked then ? If it's on the SIM card itself, then I could see that a phone upgrade wouldn't (shouldn't) have any effect. If it's on the phone, wouldn't that lock/unlock information be overwritten when the phone's ROM is upgraded? :?
re-locked
Nope, I unlocked my XDAII then upgraded the ROM to the latest and nope it didn't relock it stayed unlocked!
TJ
It's not on the sim card
lock information is found in the bootloader of the device, so it wil be not affected due a normal firmware upgrade
so if I replace the boot loader of the device then will it unlock the locked phone.

How to sim unlock G4 model

Hi all,
I am new on this forum an read a lot so far but it is not clear to me anymore. What i want to do is only a sim unlock action on my G4 model. Can i use the same tools that are mentioned for the G3 models. Please advise
robpoc said:
Hi all,
I am new on this forum an read a lot so far but it is not clear to me anymore. What i want to do is only a sim unlock action on my G4 model. Can i use the same tools that are mentioned for the G3 models. Please advise
Click to expand...
Click to collapse
There's only one way to do an actual CID unlock on a G4, and that's to pay these guys to do it for you http://www.imei-check.co.uk. But, if you just want to flash various ROMS on it, then you don't need to unlock it. Just check out the first thread in this forum and the wiki.
TaurusBullba said:
There's only one way to do an actual CID unlock on a G4, and that's to pay these guys to do it for you http://www.imei-check.co.uk. But, if you just want to flash various ROMS on it, then you don't need to unlock it. Just check out the first thread in this forum and the wiki.
Click to expand...
Click to collapse
I understand that there is not a free way to CID unlock a G4 device, but the question is, is there a way to just SIM Unlock it so you can use it with a different carrier? I understood CID unlock and SIM unlock is not the same.
Pipila said:
I understand that there is not a free way to CID unlock a G4 device, but the question is, is there a way to just SIM Unlock it so you can use it with a different carrier? I understood CID unlock and SIM unlock is not the same.
Click to expand...
Click to collapse
That's right, CID and SIM unlocking are different. If you want to SIM unlock your phone, the only option is to pay that same company I mentioned. There is no free way to SIM unlock your phone still.
robpoc said:
What i want to do is only a sim unlock action on my G4 model. Can i use the same tools that are mentioned for the G3 models. Please advise
Click to expand...
Click to collapse
Yes, the lokiwiz program worked for me to SIM unlock my 8125 G4. I can't remember the details-- I vaguely recall that version 02b worked better than the 03 version. But yes, it works for SIM unlocking a G4.
neurocutie said:
Yes, the lokiwiz program worked for me to SIM unlock my 8125 G4. I can't remember the details-- I vaguely recall that version 02b worked better than the 03 version. But yes, it works for SIM unlocking a G4.
Click to expand...
Click to collapse
Just be sure NOT to flash the button rom or any other "FULL" rom that contains IPL/SPL or you will ruin your device. It is not advisable to follow G3 instructions for your G4 device for this reason.
But, then again I am sure you already knew this because you read the wiki and the stickies right
Sim Unlocking a G4 8125
No disrespect to any of the developers here who have done shiploads of brilliant work to unlock the 8125's et al. Sadly though when reading you have to take a geat deal of care and read a lot of stuff to try to figure out what to really do because it would seem there is loads of half truth and uninformed comment being passed off as fact.
Having read 100's of posts here I launched into the SIM unlocking process and found that on my G4 8125 Phone that Lokiwiz version 0.2 threw errors and did not seem to successfully SIM unlock the phone.
So I moved up to LokiWiz 0.3a which contains LokiWizMSL.exe 845,932 Bytes. This package on my G4 Cingular 8125 running 2.25.0001 IPL and SPL, OS 2.25.11.1 and successfully unlocked the phone. When you run Lokiwiz look for the lines:
SIMLock Code is your code... Type it with another SIM in...
--------------------
Lock Status: 0100000000000000
SIMLock Code: 926***** <==== 8 Digit number
Write down the SimLock Code you need this number.
The one confusing thing is that is now totally obvious is that after you run Lokiwiz you need to swap to a SIM card from another provider to enter the code when the phone reboots, in my case I borrowed a workmates U.S. TMobile SIM Card and when the phone booted up it asked for the code that I generated above. Once that is entered your G4 phone is SIM Unlocked.
This part ain't that hard it is nerve wracking for us noobs tho.
Huge thanks to everyone whose work contributed to these tools, next chance I get I have you nominated for God.
Now I'm on to CID unlocking my phone to get WM6 and Touchflo on it. I suspect several more days reading will be required.
Phil
Unlocked Cingular 8125 G4
Thanks for the guidance.
Just installed Lokiwiz03a, ran the batch file, swapped cards, and put in the new code. Everything worked perfectly.
Thank you everyone for the software and tutorials.
YES lokiwiz03a worked flawlessly for my wizard G4 too, Now i have sim unlocked my phone, is CID unlocking same as making the device Super CID?
Easier Than Cutting Warm Butter
actually it is so simple and by the way : HERE IS A HINT:
I DID INSTALL THE ENABLERAPID.CAB AND CERT_SPCS.CAB LOCATED IN THE UTILS INFO.. AFTER I SWICHED THE SIM CARD REBOOT THE PHONE AND RUN THE lokiwiz03a.exe IT GAVE ME THE CODE.. I DIDNT HAD TO SWAP SIMS.. AND WOALA....
IT WORKS EASIER THAN MOST EXPECTED THINGS...
STOP PAYING $40 DOLARS TO UNLOCK THIS THINGS.. THESE IS A VERY NOOB GUIDE..
I AM ATTACHING THE RAPID.CAB
NOW I AM INTO MAKING MY CINGULAR 8125 WM6..
ANYSUGGESTIONS
Congratulations Phil!, I hope you find the way to CID-Unlock ours Cingular 8125.
I'll be readingo this post for future results.
TaurusBullba said:
There's only one way to do an actual CID unlock on a G4, and that's to pay these guys to do it for you http://www.imei-check.co.uk. But, if you just want to flash various ROMS on it, then you don't need to unlock it. Just check out the first thread in this forum and the wiki.
Click to expand...
Click to collapse
Does anyone know if there has been any new developments on a free method of CID unlocking a G4?
I have tried the methid mentioned earlier, I get my 9 digit number, swap the sim to a locked network, enter the 9 digit number when asked, and it seems to unlock the phone, but as soon as it tried to register on the network I am presented with the network is locked screen again.....Unless I turn the phone to flight mode and then of course it all works fine (except the phone ) any ideas why this might be?
Syngress
This works
I would like to just say how grateful i am to everyone working so hard to make all our G4 wizard users' lifes a little easier. THANKS AGAIN.
Im wondering what I need to do to get the TouchFlo on my G4 Wizard without risking bricking it (i have enough horror stories to not want this to happen). So anyone with advice id very much appreciate it or links on where i can download it.
Thanks
..
Newby
Today, I used Lokiwiz 03a. I ran it and it unlocked my Cingular G4 8125. I am now using it on T-Mobile. I works. Plain and simple.
kregar
is anyone from xda-dev working on G4 simlock unlocking?
Is there any BOX ( I saw service boxes for smartphones like JAFWM, it says it can also unlock wizard but I don't know if this info is about G4 wizard)?
I know about IMEI-CHECK. Now I just can't pay for it. I live outside of GB.
Polish PAYPAL really sucks
kubek1334 said:
is anyone from xda-dev working on G4 simlock unlocking?
Is there any BOX ( I saw service boxes for smartphones like JAFWM, it says it can also unlock wizard but I don't know if this info is about G4 wizard)?
I know about IMEI-CHECK. Now I just can't pay for it. I live outside of GB.
Polish PAYPAL really sucks
Click to expand...
Click to collapse
Lokiwiz will unlock G3 AND G4 wizards.
So...
I've tryed it.
I'm running lokiwiz on good simcard (i have polish orange simlock so Insert Orange PL SIM). It gives me code.
Then Im inserting my card (I have Plus GSM) and phone says "network is locked insert code (or somethink like that, I dont remember it now)
So Im entering unlock code from Lokiwiz. After pressing "Unlock" I see today screen. After 5 seconds it goes back to unlock code screen.
Am I doing something wrong?
IPL: 2.21.001
SPL 2.21.olip
GSM:02.71.11
Simlock: Polish Orange.
I've tryed diffrent ROMS like TNT, NBD , Polish Official wm 5 from orange.
Hard Reset is not working also.
All the time the same problem ;-)
As you see phone has hardSPL
unlock sim card for qtek9000
can i can use this soft Lokiwiz for my qtek9000?
thks
lockwiz 3a
sim unlocked my g4 8125 with it yesterday,many thanks xda people
also can anyone recommend a good wm6 rom for the 8125 thanks in advance and this is a truly amazing website

Athena Project Touch ROM Update failed

Hello,
I tried the TOUCH 3.0, but after it gets to 1% update, the htc reboots and on the pc it says "image is corrupt, please check your updater utility" I have re-downloaded the touch and same thing happens, any help?
Thanks
You are probably going to get flamed for not searching, but I believe that means your phone isn't unlocked. If you haven't used Olipro's unlocker do that then retry the update. His unlocker isn't the same as sim unlocking just in case you didn't know. Good luck to you.
I did do search and I did come up with what you are saying that the phone is not unlocked, but it is unlocked, and I purchased it as an unlock phone, this is why I am stuck. So any help would be much appreciated.
From what I understand and read is that there are two unlocks that your phone needs. Sim unlock which is what your phone has and I believe IMEI unlock which it doesn't. Olipro's unlocker will take care of that. Using the unlocker either way is just a safe bet for making sure everything works well with your device.
marek101 said:
I did do search and I did come up with what you are saying that the phone is not unlocked, but it is unlocked, and I purchased it as an unlock phone, this is why I am stuck. So any help would be much appreciated.
Click to expand...
Click to collapse
you device needs to be cid unlocked not sim. Goto athena thread and dow nload unlocker from there. Use step one to unlock then you will be able to use this rom.

Just a new 8125 G4 installed cr96 6.5wm cant sim unlock please help

i got cr96 6.5 rom installed and i ran lokiwiz03a and got the sim unlock code . ok so i put my tmobile sim in and it never asks for the unlock code it just acts like its constantly searching for network . what do i need to do ? i was gonna flash back to stock rom but idk where to find it and im scared of bricking the g4
Mine is doing the same. Anyone know the solution?
Ok, I figured it out. I had cid unlocked and then upgraded to cr96. So I ended up flashing the rom to the official windows mobile rom and then running lokiwiz. Lokiwiz provided the sim unlock code and then I entered it into the phone while still running the official rom. I then flashed the cr96 and everything was unlocked. So basically:
1 flash original windows mobile rom
2 run lokiwiz and click sim unlock
3 write down the number it gives you
4 turn phone on with a non official sim in it
5 the phone will tell you the phone is locked and give you a place where you can enter the code that lokiwiz came up with
6 enter the code
7 flash to whatever rom you want
the above assumes you are already cid unlocked

[Q] Does having SPL and a flashed rom (miri's rom) mean my phone is unlocked aswell?

Just wondering if this means that my HD2 is unlocked. Also, is there anyway to check to see if it is without trying another sim card? Thanks
SPL & a Custom ROM will not SIM unlock your phone...if you bought the phone from from the carrier call them to get the unlock code or buy one online if you need SIM unlock.

Categories

Resources