[Q] Need help with booting screen and battery !! - Android Q&A, Help & Troubleshooting

He guys !
I flashed cm10 for my xperia ion lt28 !
I flashed boot.img, entered recovery and flashed rom and gapps
But I forgot to do data reset and wipe cache and dalvik cache !!
Now it's stuck on the blue circling boot screen !
Do I wait for the battery to go dead or what ? Cause I can't remove the battery..
Any help please ? Did I brick it ?

Ok.. I managed to manually shut it down..
I did a data/factory reset.
I wiped cache and dalvik cache..
Then i flashed the fxp 204 rom aoba for my ion...
Then installed Gapps.
It still keeps loading the circling screen...
Any suggestions ?
Do I flash back to another safe rom ??

Related

Stuck at boot

Hey guys. So I tried to switch form Cyanogen to the stock 2.2 for my country, and now it's stuck in boot loop ("Android" ). What should I do? I reflashed the rom like 4 times now, cleared the cache, wiped the phone, the dalvik cache.. It can't boot =|
Thanks​
it's been fixed by flashing a different ROM right off SamFirmware.com

s2 stoped at yellow trangle never boot

help! I flashed cwm recovery then flash update (cm nightly 69) without wipe all, now stoped at yellow trangle all the time, what should i do ? please help! thank
Put out your battery then wipe again factory/data reset, wipe dalvic cache, wipe cache partition then install again the cm7
Sent from my GT-I9100 CyanogenMod 7 nightly build
Please make sure you are not flashing GT-I9100G model. Bcos it is not compatible
thanks so much i will try

[Q] [HELP] Stuck on MI logo after flashing official MIUI over XWKL1

Hello guys,
Just got my new I9100 yesterday.
Phone Specs:
PDA: I9100XWKL1
Phone : I9100DDKL1
CSC: I9100DDKL1
I flashed CF Root I9100XWKL1 and rooted my phone. Later I downloaded official MIUI and flashed it via CWM Recovery. Wiped cache and Dalvik cache. Now the phone is stuck at MI logo. I just hear the galaxy sII startup tone and the phone shows logo and does not moves ahead. What to do now guys? Have I went somewhere wrong?? Guide me
Try reflashing the rom without any wipe.
Or boot into recovery if you can & do a wipe/factory reset.
m2smoe said:
Try reflashing the rom without any wipe.
Click to expand...
Click to collapse
I tried reflashing still stuck at logo.
MistahBungle said:
Or boot into recovery if you can & do a wipe/factory reset.
Click to expand...
Click to collapse
Done. Booted now after factory reset Thanks
As strange as this may sound, I usually wipe cache and dalvik before flashing the ROM...I had similar issues with CM7 when I wiped cache and dalvik after install. Enter recovery again, wipe cache and dalvik and flash ZIP, then reboot and see...
Otherwise, the only other possible explaination is that the first bootup does take some time...but usually never pauses or stops the animation.
0semaj0 said:
As strange as this may sound, I usually wipe cache and dalvik before flashing the ROM...I had similar issues with CM7 when I wiped cache and dalvik after install. Enter recovery again, wipe cache and dalvik and flash ZIP, then reboot and see...
Otherwise, the only other possible explaination is that the first bootup does take some time...but usually never pauses or stops the animation.
Click to expand...
Click to collapse
Hmmm that's not very strange. Also I was considering that first boot will take time as dalvik cache is prepared and then system gets running. But the wait time was abnormal in first case.
Sent from my GT-I9100 using Tapatalk

gt- i9300 always enter the recovery mode

i have updated my gs3 gt-i9300 from omega 44.1 to 46.1
at the begging i didnt make full wipe or cache or dalvik.. anyway the mobile couldnt operate after installing the rom !! it restarted on the the recovery mode (also it shows a small red vertical red line on the top-left of the screen before entering the recovery mode) ..
i wiped the full wipe cache and dalvik.. then install the rom again... still the same issue.... can anybody help ?
yes, do a full wipe factory reset from recovery and re-flash.
luaymaani said:
i have updated my gs3 gt-i9300 from omega 44.1 to 46.1
at the begging i didnt make full wipe or cache or dalvik.. anyway the mobile couldnt operate after installing the rom !! it restarted on the the recovery mode (also it shows a small red vertical red line on the top-left of the screen before entering the recovery mode) ..
i wiped the full wipe cache and dalvik.. then install the rom again... still the same issue.... can anybody help ?
Click to expand...
Click to collapse
Ask in the rom thread

[Q] my galaxy s3 i9300 is stuck on cyanogenmod logo

Hi, today i was starting too update my android to 5.0 lollipop, but some how it didn't work.
when i reboot it goes stuck on the cyanogenmod logo. i waited like for an hour long, but still it wont start my phone ;( before i wanted too update to lollipop i wiped cache and data etc... pls help me, i think i bricked my phone. is there any solution to repear it? srry for my bad english.
Anyone? pls help
Go to recovery mode,factory reset/wipe data and cache partition
Mounts and storage>format system,data and cache,
Go to advance>wipe dalvik cache then reinstall the rom...

Categories

Resources