i need help please - Legend Q&A, Help & Troubleshooting

Just got a 2nd hand legend, I cleared the data (hard reset?) without a storage card in it.
now stuck in GERMAN. I have tried to hard reset by useing volume buttons and power key but this does not appear to work!

sara7 said:
Just got a 2nd hand legend, I cleared the data (hard reset?) without a storage card in it.
now stuck in GERMAN. I have tried to hard reset by useing volume buttons and power key but this does not appear to work!
Click to expand...
Click to collapse
How to go in Recovery, Fastboot mode and Bootloader mode.
=====================================================================
1) Bootloader Mode:
While your devices is powerd off, press "Power" + "Vol. Down"
until Bootloader screen appears.
-----------------------------------------------------------------------------
1.5) How to use buttons in Bootloader,Recovery and Fastboot mode:
"Volume Up" : go to previous item
"Volume Down": go to next item
"Power" : to select item
-----------------------------------------------------------------------------
2) Fastboot Mode
While in bootloader mode,
press power button and you are in fastboot mode
-----------------------------------------------------------------------------
3) Recovery Mode
While in bootloader mode, press "Vol. Down" and after
press "Power" button and after that you are in a screen
with a phone and an alert press "Vol. Up" + "Power" to go in recovery

sara7 said:
Just got a 2nd hand legend, I cleared the data (hard reset?) without a storage card in it.
now stuck in GERMAN. I have tried to hard reset by useing volume buttons and power key but this does not appear to work!
Click to expand...
Click to collapse
Remove and then reinsert the battery.

Related

Bootloader mode crashed

I can not put my your hermes into bootloader mode (side ok + power button + softreset) to check out the SPL version. Is there other possibility to flash a new ROM?
I bouth an used Vario II (Herm300) with boot problems, the PDA is booting until this screen (picture) and than after 10 second it reset by itself. After the Reset the PDA boot again the same screen.
Had someone similar problems ?
Thanks.
To enter bootloader mode you have to press Ok + Power button only without Soft Reset
0xff.0xff said:
To enter bootloader mode you have to press Ok + Power button only without Soft Reset
Click to expand...
Click to collapse
ummm, wrong. You hold power + side OK then reset with stylys and keep holding the power and side OK, you should enter boot mode at which point you can let go of the two buttons.
eagercrow said:
ummm, wrong. You hold power + side OK then reset with stylys and keep holding the power and side OK, you should enter boot mode at which point you can let go of the two buttons.
Click to expand...
Click to collapse
Oh, sorry, your truth... you don't have to press soft reset only if device is switched off... sorry for confusion

[Q] About forgot password (strange

(sorry about my chinglish )
So here's how:I locked my nexus10 and forgot the password, and I do not see the "Forgotten" button on the screen and also I didn't turn USB debugging mode on, so is there any possibility I can save my data instead of cleaning them up? Thank you (btw, I deleted the original recover files(because I once booted Ubuntu Touch on it) how can I reset it anyway?) Tanks a lot
Don't think there's a way..
And you should be glad because if it was possible anyone could break into your device.
P.S.
chinglish - like!
eytan123 said:
Don't think there's a way..
And you should be glad because if it was possible anyone could break into your device.
P.S.
chinglish - like!
Click to expand...
Click to collapse
yeah........I see, so how can I clean everything, the recovery is dead and I didn't turn the debugging mode on
Right from Google:
1.If your tablet is on, power it off.
2.Press and hold Power, Volume Up, and Volume Down at the same time for several seconds. You will see the word Start with an arrow drawn around it.
3.Press Volume Down twice, until you see the option Recovery mode.
4.Press Power to restart into Recovery mode. You should see an image of an Android with a red exclamation point.
5.While holding down Power, press Volume Up.
6.Use the Volume keys to scroll to Wipe data/factory reset and press Power to select it.
7.Scroll down to Yes - erase all user data and press Power to select it.
Note: If at any point during the above steps your tablet becomes unresponsive, you can restart it by holding down the Power button for several seconds.
eytan123 said:
Right from Google:
1.If your tablet is on, power it off.
2.Press and hold Power, Volume Up, and Volume Down at the same time for several seconds. You will see the word Start with an arrow drawn around it.
3.Press Volume Down twice, until you see the option Recovery mode.
4.Press Power to restart into Recovery mode. You should see an image of an Android with a red exclamation point.
5.While holding down Power, press Volume Up.
6.Use the Volume keys to scroll to Wipe data/factory reset and press Power to select it.
7.Scroll down to Yes - erase all user data and press Power to select it.
Note: If at any point during the above steps your tablet becomes unresponsive, you can restart it by holding down the Power button for several seconds.
Click to expand...
Click to collapse
The recovery has been deleted by me when I boot Ubuntu Touch on it
u cant get download mode and flash recovery? debuging must be on to do it? i dont think should be on.
Sent from my GT-I9100
Fastboot
You can use Fastboot without USB Debugging enabled.
"To use fastboot, power off, then hold down the power button and both volume buttons. That will take you to the bootloader screen where you, or the toolkit, can do fastboot commands."
I've attached a CWM Recovery image for your device.
Place it somewhere on your computer and open the Terminal application on your computer. Run the following command:
fastboot flash recovery <image location>
Then you can backup /data using advanced backup, perform a factory reset, CREATE A FULL BACKUP, then restore /data using advanced restore.

Can't boot into recovery mode

Hello,
I'm trying to install custom ROM but I can't boot into recovery mode. It's just stuck on "htc powered by android" screen. I can boot into Android normally and also I Unlocked bootloader but can't do anything else because I can't enter recovery mode. My phone is HTC One M8s.
Thanks
If u try volume down + volume up + power key then release power key
SHA PHONEIX said:
If u try volume down + volume up + power key then release power key
Click to expand...
Click to collapse
Thanks for reply. When should I do that combination? While the phone is off or while is stuck on this screen? How long should I hold power key? Just for a second or until something happens?
milosdallas said:
Thanks for reply. When should I do that combination? While the phone is off or while is stuck on this screen? How long should I hold power key? Just for a second or until something happens?
Click to expand...
Click to collapse
1) First remove battery from your phone
2) then insert battery
3) then press volume down + volume up
4) then soft press power key
5) if ur phone is power on
6) remove hand from power key
7) don't release volume down + up key
SHA PHONEIX said:
1) First remove battery from your phone
2) then insert battery
3) then press volume down + volume up
4) then soft press power key
5) if ur phone is power on
6) remove hand from power key
7) don't release volume down + up key
Click to expand...
Click to collapse
Battery is not removable on this phone but I tried your steps, it is just booting android...
K reinstall twrp recovery mode then try this
SHA PHONEIX said:
K reinstall twrp recovery mode then try this
Click to expand...
Click to collapse
Same thing, it got booted up in Android but this time it says "Safe mode" in the bottom left corner (can't remember if it said that last time).
Power off ur phone before following the above key combination and wait until the screen turns back on.
Don't understand you, but I think you should go to download mode and reinstall TWRP.

Help me unbrick my phone Please

I was factory reset > installing 21a but i forgot the 21a file wasn't in the sd card.
Now the phone is in the lg screen forever and i can't find a way to shut down the phone.
Connect via usb cable to PC,
then do a force reset (Power + Volume down), quickly keep only Volume Down pressed to get into fastboot/bootloader mode.
Once it's in fastboot mode ("bootloader"), tap volume down to switch between "Reboot" and "Shut down".
Once "Shut down" is displayed gently tap the power button, that should turn the phone off.
zacharias.maladroit said:
Connect via usb cable to PC,
then do a force reset (Power + Volume down), quickly keep only Volume Down pressed to get into fastboot/bootloader mode.
Once it's in fastboot mode ("bootloader"), tap volume down to switch between "Reboot" and "Shut down".
Once "Shut down" is displayed gently tap the power button, that should turn the phone off.
Click to expand...
Click to collapse
Thanksyou so much for replying!
should i flash 21a in lgup if i want to unbrick or do i go into twrp?

Need help with password locked unknown tablet

Hi,
My grandfather locked his chinese tablet without knowing how.
Each time we start the tablet we arrive on an input field asking for a password we don't have.
I can't found how to reboot in recovery, however I can boot to fastboot mode with power and vol up keys.
The tablet is branded as a Kliver Klipad KL3889, but there is no other information on the vendor website (klipad DOT fr)
The user manual only says A64 Quad Core CPU and Mali 400MP GPU.
The tablet is running Android 8.1 Go edition, and shows up as "Onda (unverified)" with 1f3a:1006 id according to lsusb command.
When booted in fastboot mode, it shows up with a different id on lsusb :
1f3a:1010 Onda (unverified)
I can not reach the tablet using adb, and when I tried a fastboot
reset using the following commands :
Code:
fastboot -i 0x1f3a erase cache
fastboot -i 0x1f3a erase data
fastboot -i 0x1f3a erase userdata
all I get is the following error :
FAILED (remote: :secure mode,fastboot limited used)
Click to expand...
Click to collapse
What are my options ? Is there a way to fully reset this device ?
perhaps web search: JTAG + tablet details. Some disassembly required. SuperUser has previously recommended Ort JTag.
Factory reset from recovery mode
AnierinB said:
Factory reset from recovery mode
Click to expand...
Click to collapse
As I previously said, I can't access recovery mode. I've tried all keys combinations I could find, and the only one working (Vol Up + power) boot into fastboot mode, not recovery mode.
yodazz said:
As I previously said, I can't access recovery mode. I've tried all keys combinations I could find, and the only one working (Vol Up + power) boot into fastboot mode, not recovery mode.
Click to expand...
Click to collapse
Hi , try this :
1) Turn off the tablet
2) Hold "Volume +" and turn on the tablet
3) Once you see KLIPAD logo on your display, release the "ON" button (or power) while holding "Volume +"
4) You must arrive on the Android logo, and you will probably get the message "No command"
5) You can let go of "Volume +"
And that's where it becomes interesting:
6) Press "ON" (or power), and while holding the button, a pulse on "Volume +"
7) You finally arrive at the menu of restoration
You navigate through the menu by means of the volume keys, and the "ON" (or power) button acts as validation.
Choose "data / factory reset", confirm
Then "reboot system now" and you're done, if that doesn't work try the same process just with VOl- , also what you can try is :
1. Turn off your device
2. Press and hold Vol - and power button , and once you see Logo , fast release both buttons and see if you are into Recovery mode.
Teddy Lo said:
Hi , try this :
1) Turn off the tablet
2) Hold "Volume +" and turn on the tablet
3) Once you see KLIPAD logo on your display, release the "ON" button (or power) while holding "Volume +"
4) You must arrive on the Android logo, and you will probably get the message "No command"
5) You can let go of "Volume +"
And that's where it becomes interesting:
6) Press "ON" (or power), and while holding the button, a pulse on "Volume +"
7) You finally arrive at the menu of restoration
You navigate through the menu by means of the volume keys, and the "ON" (or power) button acts as validation.
Choose "data / factory reset", confirm
Then "reboot system now" and you're done, if that doesn't work try the same process just with VOl- , also what you can try is :
1. Turn off your device
2. Press and hold Vol - and power button , and once you see Logo , fast release both buttons and see if you are into Recovery mode.
Click to expand...
Click to collapse
Thanks.
It works like you said until step 4 where I get the android logo, but no "No command" message.
Then when I hold ON button while pressing VOL+ it doesn't do anything.

Categories

Resources