I recently picked one up used because I needed something smaller and more durable than my GS3.
But I've noticed that my battery cover doesn't seem to clip on correctly.
When I hold it a certain way, the clips snap back in, but then pop right out. I also noticed that the corner
where the cell phone strap is creeks.
Is there a special way to put it on that I am not aware of or did I just buy a phone with a faulty back cover?
Thanks!
Hey guys,
I got an official S-view cover from ATT store (Black) for my new note 3. I love it except for one major problem. When I fold the cover open around the back and set it down on something like a desk or table. Eventually the phone will sit completely flat against the cover and I am noticing that the cover will engage S-view mode on the phone while it it folded around the back of the phone. This is super annoying, because when its in S-View mode the phone is essentially locked and I can't do anything with it unless I un-fold the cover from around the back. I thought maybe I had a bad cover with super strong magnets or something so I returned it to ATT and bought another one from T-Mobile (This was the advice I got from Samsung support). I having the exact same problem with this one. Now I think its my phone. I can replicate this problem anytime by simply putting pressure on phone the and cover while it is folded around the back. When I hold the phone in my hand with the cover around the back it is not as prevalent because phone usually is not sitting completely flat to the cover (because the cover is still new). Once it breaks in and gets flimsy this will happen all the time completely limiting phone functional while the cover is around the back. I had the an S-View cover on a S4 and it never had this problem. Can any of you guys replicate this issue or do I have a bad phone. Please help, I need to know if I need to exchange my phone. Thanks in advance.
davparks said:
Hey guys,
I got an official S-view cover from ATT store (Black) for my new note 3. I love it except for one major problem. When I fold the cover open around the back and set it down on something like a desk or table. Eventually the phone will sit completely flat against the cover and I am noticing that the cover will engage S-view mode on the phone while it it folded around the back of the phone. This is super annoying, because when its in S-View mode the phone is essentially locked and I can't do anything with it unless I un-fold the cover from around the back. I thought maybe I had a bad cover with super strong magnets or something so I returned it to ATT and bought another one from T-Mobile (This was the advice I got from Samsung support). I having the exact same problem with this one. Now I think its my phone. I can replicate this problem anytime by simply putting pressure on phone the and cover while it is folded around the back. When I hold the phone in my hand with the cover around the back it is not as prevalent because phone usually is not sitting completely flat to the cover (because the cover is still new). Once it breaks in and gets flimsy this will happen all the time completely limiting phone functional while the cover is around the back. I had the an S-View cover on a S4 and it never had this problem. Can any of you guys replicate this issue or do I have a bad phone. Please help, I need to know if I need to exchange my phone. Thanks in advance.
Click to expand...
Click to collapse
I've got the same problem here. It seems to be an issue of either the little magnet on the bottom of the cover being too strong or the sensor on the phone being too sensitive. Definitely annoying and poorly designed. I don't know of any solution. I just wedge my finger behind the cover to prevent it from tripping, but that's hardly a solution.
Can't help you with this issue.. but I got bought two knock-offs on the web and never experience anything like that. Probably the way it's built with the OEM case.
I have the same problem with my sview case for note 3.
Interesting issue. I have the wireless charging s-view case and I can confirm that this dos not happen with it. I guess that is due to the thicker back cover portion.
Has anybody ever successfully replaced the back cover & buttons on the Verizon version with the international versions? Is this even possible? From what I've been looking at, what you would have to do is replace the rear housing & the door and that should be it.
Would this interfere with wireless charging?
Does the ports line up?
Will the rear door even fit back on?
The reason I want to do this is so that i will be able to use regular cases for this phone instead of using the limited selection of cases for Verizon
EDIT: Nevermind, it's not possible. I can tell just by looking at the inside of the battery cover of each phone. Different contacts.
Due to wireless charging. Also the reason buttons are different.
Hello Everyone,
I did a search but I didn't see anyone else posting something about this, but it seems likes my display glass is starting to separate from my phone about halfway down the body. The glass is now a hair higher that the actual plastic body on the left and I can physically push it down and the screen actually shows a wave, like when pressing too hard on an LCD or touching a non-touchscreen. I was wondering if anyone else was having this issue?
I am trying to determine my best option for warranty service as I used the transfer the upgrade trick on VZW and don't want to throw up any red flags. I also want to keep my battery door because I have the wireless charging sticker on it.
GTiceman said:
Hello Everyone,
I did a search but I didn't see anyone else posting something about this, but it seems likes my display glass is starting to separate from my phone about halfway down the body. The glass is now a hair higher that the actual plastic body on the left and I can physically push it down and the screen actually shows a wave, like when pressing too hard on an LCD or touching a non-touchscreen. I was wondering if anyone else was having this issue?
I am trying to determine my best option for warranty service as I used the transfer the upgrade trick on VZW and don't want to throw up any red flags. I also want to keep my battery door because I have the wireless charging sticker on it.
Click to expand...
Click to collapse
Well that's no good! Sorry to hear that, I've not seen anywhere online either where people are having that problem.
As far as your options go though... Not sure you have many. You can either pay someone to replace the screen, if it's repairable and you can find someone.... Or obviously you'd have to just go for the insurance... I'm curious, how would you throw up any red flags if in fact there is something as obviously detected as your screen? I've not done the " upgrade trick " myself so bear with me if that's a silly question.
Well I might be able to get replaced under Manufacturer Warranty as there are no signs of damage. I also do not have insurance on the phone.
I'm having the same problem, the middle left edge of my screen is lifting up (very slightly) as well. Light bleeds through the edge of the screen and the lcd changes color when I press with moderate pressure. I plan on contacting Verizon for warranty support tmrw.
So I spoke to VZW and they told me that the screen lifting off from the bezel is considered a physical defect rather than a manufacturers defect so it is not covered under warranty support. FWIW my phone has not sustained any major drops or any major damage at all...
Do you guys have the qi sticker on yours? Mine does and it's a really tight fit... I was thinking that maybe it could be pushing out the screen
My Verizon LG G3 screen is now separating from the midframe on both sides in the middle of each side. It is up about a 16th of an inch, can be pushed easily back down but doesn't stay. Light leaks from the edges.
Sent from my VS985 4G using Tapatalk
---------- Post added at 05:10 PM ---------- Previous post was at 04:27 PM ----------
I discovered I had a spare sd chip and spare sim stored under my battery. When I removed them both, reinstalled the battery and qi circle case, the light leaking was gone.
Looks like the G3 is pretty flexible and that the display is not glued down except at the corners. If you crowd it in the back, the display can bulge out the front of the frame. This doesn't mean its broken or defective, just tight.
Sent from my VS985 4G using Tapatalk
Same thing has happened here on the left hand side only. I must admit I decided to store a spare SIM under the battery and a day or so later noticed a raised edge on the left side of the screen. I immediately realised this must be the case and removed the spare SIM but now the left side it ever so slightly raised, I notice this most when using the phone in the dark/dark areas as light bleeds out along that raised edge.
I may try get a replacement but since this is the second thing that occurred with the LG G3 for me (first was cracked camera lens) I may just come to the conclusion the LG cant cut it against my old Galaxy S3, which is still going without fault all these years. Might just be eyeing up a new S6 sometime in the future.
Just coming here to say that this is also happening to my device, only on the left side, as well.
I am trying to activate the warranty to get it fixed.
TTSDA said:
Just coming here to say that this is also happening to my device, only on the left side, as well.
I am trying to activate the warranty to get it fixed.
Click to expand...
Click to collapse
Me too.. Gonna see about getting it swapped
Did you guys bought your phone New from the store ? Like Verizon ?
This issues sound like the aftermarket LCD screens sold on eBay. I have bought 3 LCD screens from eBay. For the LG G2 twice and one for the G3. Once installed and a few uses on the phone, parts of the glass lifts up from the LCD and frame. That's cause they're high quality not genuine LG screens... They don't have the good loca glue on the screen.
I am experiencing the same problem. i only bought it in June 2015 and I don't know how that happened because I haven't even dropped it once.
I am thinking to claim the warranty. Because it seems like the glue has come off of it.
Yup. Mine is doing this too now... awesome! Left side as well. This is my 3rd G3 since July 2014 - I'm done with LG.
From what I've seen on other phones, the screen is often held on by some kind of adhesive. Considering this phone gets red hot if you do two things, like talk on the phone and try to web browse (like so hot it's hard to even hold), it probably slowly breaks down the adhesive holding the screen on.
My vs985 display lifts a bit in the middle along both sides, but only when I have a spare sim or sim adapter attached back there with the battery.
Doesn't take much.
Sent from my Nexus 6 using Tapatalk
i have this problem too in my phone screen...
ivann23 said:
i have this problem too in my phone screen...
Click to expand...
Click to collapse
Same. Light leaks out the Sides
Sent from my LG-VS985 using Tapatalk
A solution would be a case that cover that area of the phone. for example:
http://www.amazon.com/G3-Case-Bastex-Heavy-Protective/dp/B00PIYNE7Y/ref=sr_1_12?s=wireless&ie=UTF8&qid=1448743612&sr=1-12&keywords=g3+case
It's that Wireless Charging unit in the cover that brings the display up. Notice how the bleeding disappears when you take the cover off.
If you're not big on wireless charging, I suggest you perform operations on your backcover and get that bump out of there.
My LG G3 seemed to be having the same problem as well. It has beeen lifting slightly on both of the long sides and if it is on i can look at the side of the phone and see light escaping from the display. I orginally thought the my screen was somehow bent, but out of curiousity i inspected the back on the phone. In that i found that somehow my battery seems to be pushing my display out of the midframe... When i take the battery out the screen returns to the midframe on its own. When i try to put the battery back in it pokes out slighlty then when i put it in completely the display pops back out slightly on both sides again. I dont know how to fix this issue but if someone could figure it out that would be appericated.
jncool101 said:
My LG G3 seemed to be having the same problem as well. It has beeen lifting slightly on both of the long sides and if it is on i can look at the side of the phone and see light escaping from the display. I orginally thought the my screen was somehow bent, but out of curiousity i inspected the back on the phone. In that i found that somehow my battery seems to be pushing my display out of the midframe... When i take the battery out the screen returns to the midframe on its own. When i try to put the battery back in it pokes out slighlty then when i put it in completely the display pops back out slightly on both sides again. I dont know how to fix this issue but if someone could figure it out that would be appericated.
Click to expand...
Click to collapse
Have you tried a new battery? Is your battery swollen? Sometimes they get bloated when they go bad.
Hey all, i recently accidentally broke the back case of my LG G3, i thought if i can use my simple rubber cover as a back case?
Your back cover had NFC chip implemented into that. If you don't mind losing NFC, you can use everything that prevents battery from sliding off, because it will shut down your phone, obviously.